Cleaning and Disinfection
MAINTENANCE
55
4-1. Hood Assembly
• Snap-open access port packing
Remove the rubber packings from the snap-open access
ports. Immerse and clean them in a disinfectant solution.
To replace each rubber packing to its former position, be
sure to smooth out wrinkles along the packing lip so that the
access port packing will fit perfectly in the groove around
the frame of the snap-open access port as shown in the fig-
ure on the right.
CAUTION
쎲 The snap-open access port packings are de-
signed for the unit only. Do not attach any other
packings to the unit.
• Admittance panel packing
Remove the rubber packings from the admittance panels.
Immerse and clean them in a disinfectant solution.
Snap-open access port packing
Packing lip
Frame
Admittance panel packing
• X-ray cassette tray door packing
Remove the packing from the X-ray cassette tray door. Im-
merse and clean it in a disinfectant solution. To replace the
packing to its former position, fit the packing in the groove
around the X-ray cassette tray door.
X-ray cassette tray door packing
•Tube introduction slit assembly
Remove the packings from the tube introduction slit assem-
blies. Immerse and clean them in a disinfectant solution.
Tube introduction
slit assembly
packing
To Next Page
Loading...
