Disassembly and Replacement Procedures
126
6-4-4. Replacing the Power Cord Inlet
(1) Remove the power box.
See (1) ~ (3) in “6-4-3. Replacing the Heater Con-
trol Board (for the Incu
i
).”
(2) Remove the connecting terminal of the power cord
inlet. Remove the two sems screws (M3 x 6) of the
connecting terminal of the power cord inlet con-
nected to the fuse holder with a Phillips screwdriver.
Sems screw (M3x6)
(3) Remove the protective earth terminal of the power
cord inlet.
Remove the sems screw (M4 x 8) fixing the protec-
tive earth terminal of the power cord inlet connected
to the power box with a Phillips screwdriver. For
details, see “[8] Wiring Diagram.”
Sems screw (M4x8)
(4) Remove the power cord inlet from the power box.
Remove the two sems screws (M3 x 8) with a Phillips
screwdriver.
Sems screw (M3x8)
(5) Reassembly: Reassemble in the reverse order of dis-
assembly.
To Next Page
Loading...
