From:
<sip:ContactUser@HostName>;tag=1c1397576231
To: <sip: ContactUser@HostName >
Call-ID: 1397568957261200022256@10.33.37.78
CSeq: 1 REGISTER
Contact:
<sip:ContactUser@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-Gateway
-MP-118
FXS_FXO/v.5.40A.008.002
Content-Length: 0
The Trunk Group account registration is not effected by the
parameter IsRegisterNeeded.
Notes:
If registration to an IP Group(s) fails for all the accounts defined
in this table for a specific Hunt Group, and if this Group
includes all the channels in the , the Hunt Group is set to Out-
Of-Service if the parameter OOSOnRegistrationFail is set to 1
(refer to ''Proxy & Registration Parameters'' 94 on page ).
Contact User Defines the AOR user name. It appears in REGISTER From/To
headers as ContactUser@HostName, and in INVITE/200 OK
Contact headers as ContactUser@<device's IP address>. If not
configured, the 'Contact User' parameter from the 'IP Group Table'
page is used instead.
[Account_ContactUser]
Note:
Application Type
If registration fails, then the user part in the INVITE Contact
header contains the source party number.
[Account_ApplicationType]
Note: This parameter is not applicable.
3.3.4.4 Coders and Profile Definitions
The Coders And Profile Definitions submenu includes the following page items:
Coders (refer to ''Configuring Coders'' 105 on page )
Coder Group Settings (refer to ''Configuring Coder Groups'' 107 on page )
Tel Profile Settings (refer to ''Configuring Tel Profiles'' 108 on page )
IP Profile Settings (refer to ''Configuring IP Profiles'' 110 on page )
Implementing the device's Profile features, provides the device with high-level adaptation
when connected to a variety of equipment (at both Tel and IP sides) and protocols, each of
which requires different system behavior.
You can assign different Profiles (behavior) per call, using the call routing tables:
'Tel to IP Routing' page (refer to ''Configuring the Tel to IP Routing Table''
131
on page
)
'IP to Hunt Group Routing' page (refer to ''Configuring the IP to Trunk Group Routing''
135
on page )
In addition, you can associate different Profiles per the device's channels.
To Next Page
Loading...
