AudioCodes Media Pack MP-124 - Supplementary Services Parameters; Caller ID Parameters; Table 6-33: Caller ID Parameters

SIP User's Manual 288 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Disconnect Call Digit
Pattern
Determines a digit pattern that when received from the Tel side,
indicates the device to disconnect the call.
The valid range is a 25-character string.
[TelDisconnectCode]
Digit To Ignore Digit Pattern A digit pattern that if received as Src (S) or Redirect (R) numbers is
ignored and not added to that number.
The valid range is a 25-character string.
[DigitPatternDigitToIgnore
]
6.8 Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
6.8.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Table 6-33: Caller ID Parameters
Parameter Description
Web: Asserted Identity Mode
EMS: Asserted ID Mode
Determines whether P-Asserted-Identity or P-Preferred-Identity
is used in the generated INVITE request for Caller ID (or
privacy).
[AssertedIdMode]
 [0]

Disabled = None (default)
[1]

Adding PAsserted Identity
[2]
The Asserted ID mode defines the header (P-Asserted-Identity
or P-Preferred-Identity) that is used in the generated INVITE
request. The header also depends on the calling Privacy
(allowed or restricted).
The P-Asserted-Identity (or P-Preferred-Identity) headers are
used to present the originating party's Caller ID. The Caller ID
is composed of a Calling Number and (optionally) a Calling
Name.
P-Asserted-Identity (or P-Preferred-Identity) headers are used
together with the Privacy header. If Caller ID is restricted (P-
Asserted-Identity is not sent), the Privacy header includes the
value 'id' ('Privacy: id'). Otherwise, for allowed Caller ID,
'Privacy: none' is used. If Caller ID is restricted (received from
Adding PPreferred Identity
Tel or configured in the device
Web: Caller ID Transport Type
EMS: Transport Type
), the From header is set to
<anonymous@anonymous.invalid>.
Determines the device's behavior for Caller ID detection.
[CallerIDTransportType]
 [0]

Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.
[1]

Relay = (Currently not applicable.)
[3] Mute = The caller ID signal is detected from the Tel side
and then erased from the voice stream (default).
Note:
Caller ID detection is applicable only to FXO interfaces.