3.3.4.9 Endpoint Settings
The Endpoint Settings submenu allows you to configure analog (FXS/FXO) port-specific
parameters. This submenu includes the following page items:
Authentication (refer to ''Configuring Authentication'' 142 on page )
Automatic Dialing (refer to ''Configuring Automatic Dialing'' 143 on page )
Caller Display Information (refer to ''Configuring Caller Display Information''
144
on page
)
Call Forward (refer to ''Configuring Call Forward'' 146 on page )
Caller ID Permissions (refer to ''Configuring Caller ID Permissions'' 147 on page )
Call Waiting (refer to ''Configuring Call Waiting'' 148 on page )
3.3.4.9.1 Configuring Authentication
The 'Authentication' page defines a user name and password for authenticating each
device port. Authentication is typically used for FXS interfaces, but can also be used for
FXO interfaces.
Notes:
• The 'Authentication Mode' parameter (configured in ''Configuring Proxy
and Registration Parameters'' 94 on page ) determines whether
authentication is performed per port or for the entire device. If
authentication is performed for the entire device, the configuration in the
'Authentication' page is ignored.
• If either the user name or password field is omitted, the port's phone
number (defined in Configuring the Endpoint Phone Numbers
149
on page
) and global password (refer to the parameter 'Password' described in
''Configuring Proxy and Registration Parameters'' 94 on page ) are used
instead.
• You can also configure Authentication using the ini file table parameter
Authentication (refer to ''SIP Configuration Parameters'' 252 on page ).
To Next Page
Loading...
