AudioCodes Media Pack MP-124 - Figure 3-72: SAS Configuration

Version 5.8 121 September 2009
SIP User's Manual 3. Web-Based Management
 To configure the Stand-Alone Survivability parameters:
1. Open the 'SAS Configuration' page (Configuration tab > Protocol Configuration
menu > SAS submenu > Stand Alone Survivability
Figure 3-72: SAS Configuration Page
page item).
2. Configure the parameters as described in ''SIP Configuration Parameters''
252
on page
.
3. Click the Submit
4. To save the changes to flash memory, refer to ''
button to apply your changes.
Saving Configuration'' 167 on page .
To configure the SAS Routing table, under the SAS Routing group, click the SAS Routing
Table
button to open the 'IP2IP Routing Table' page. For a description of this table,
refer to ''Configuring the IP2IP Routing TablE (SAS)'' on page 122.