AudioCodes Media Pack MP-124 - 3.3.4.9.4 Configuring Call Forward

SIP User's Manual 146 Document #: LTRT-65412
MP-11x & MP-124
3.3.4.9.4 Configuring Call Forward
The 'Call Forwarding Table' page allows you to forward (redirect) IP-to-Tel calls (using SIP
302 response) originally destined to specific device ports, to other device ports or to an IP
destination.
Notes:
• Ensure that the Call Forward feature is enabled (default) for the settings
on this page to take effect. To enable Call Forward, use the parameter
EnableForward (''Configuring Supplementary Services'' 114 on page ).
• You can also configure the Call Forward table using the ini file table
parameter FwdInfo.
 To configure Call Forward per port:
1. Open the 'Call Forward Table' page (Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Call Forward
Figure 3-85: Call Forward Table Page
page item).
2. Configure the Call Forward parameters for each port according to the table below.
3. Click the Submit
4. To save the changes to flash memory, refer to ''
button to save your changes.
Saving Configuration'' 167 on page .
Table 3-25: Call Forward Table
Parameter Description
Determines the scenario for forwarding a call.
Forward Type
 [0]

Deactivate = Don't forward incoming calls (default).
[1]

On Busy = Forward incoming calls when the port is busy.
[2]

Unconditional = Always forward incoming calls.
[3]

No Answer = Forward incoming calls that are not answered within
the time specified in the 'Time for No Reply Forward' field.
[4]

On Busy or No Answer = Forward incoming calls when the port is
busy or when calls are not answered within the time specified in the
'Time for No Reply Forward' field.
[5]
Do Not Disturb = Immediately reject incoming calls.
The telephone number or URI (<number>@<IP address>) to where the
call is forwarded.
Forward to Phone
Number