AudioCodes Media Pack MP-124 - 3.3.4 Protocol Configuration

Version 5.8 91 September 2009
SIP User's Manual 3. Web-Based Management
3.3.4 Protocol Configuration
The Protocol Configuration menu allows you to configure the device's SIP parameters
and contains the following submenus:

 Protocol Definition (refer to ''
Applications Enabling (refer to Enabling Applications on page 91)
Protocol Definition'' 91 on page )
 Proxies/IpGroups/Registration (refer to ''Proxies, IP Groups, and Registration''
93
on
page )
 Coders And Profile Definitions (refer to ''Coders and Profile Definitions'' 104 on page )
 SIP Advanced Parameters (refer to ''SIP Advanced Parameters'' 112 on page )

 Manipulation Tables (refer to ''
SAS (refer to SAS Parameters on page 120)
Manipulation Tables'' 124 on page )
 Routing Tables (refer to ''Routing Tables'' 129 on page )


Endpoint Settings (refer to Endpoint Settings on page 141)

Endpoint Number (refer to Configuring Endpoint Phone Numbers on page 149)
Hunt Group (refer to ''Trunk Groups'' 150 on page )
3.3.4.1 Enabling Applications
The 'Applications Enabling' page allows you to enable the SAS application.
Note: For enabling the SAS application, a device reset is required.
 To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > Protocol Configuration
Figure 3-57: Applications Enabling Page
menu > Applications Enabling page item).
2. Save the changes to the device's flash memory and reset the device (refer to ''Saving
Configuration'' 167 on page ).