5.5 Configuring Advanced IPSec/IKE Parameters
After you have pre-configured IPSec via SSH (refer to ''Securing EMS-Device
Communication'' on page 196), you can optionally configure additional IPSec and IKE
entries for other SNMP Managers aside from the EMS.
Note: Do not remove the default IPSec and IKE tables that were previously loaded
to the device when you enabled IPSec.
To configure IPSec/IKE tables:
1. In the MG Tree, select the device.
2. On the Tab bar, select General Configuration, and then click Info & Security
3. Select the
; the
'MG Info and Security Provisioning' screen is displayed.
IPSec Table
4. Select the
tab; the 'IPSec Table' screen is displayed.
button to add a new entry, and then click Yes
Figure 5-4: IPSec Table Screen
at the confirmation prompt;
a row is added to the table.
5. Double-click each field to insert required values.
6. Right-click the new entry, and then from the shortcut menu, choose Unlock rows
7. Click
.
Save, and then Close
8. Select the
.
IKE Table
9. Repeat steps 4 through 7.
tab; the 'IKE Table' screen appears.
To Next Page
Loading...
