AudioCodes Media Pack MP-124 - Figure 3-84: Caller Display Information

Version 5.8 145 September 2009
SIP User's Manual 3. Web-Based Management
 To configure the Caller Display Information:
1. Open the 'Caller Display Information' page (Configuration tab > Protocol
Configuration menu > Endpoint Settings submenu > Caller Display Information
Figure 3-84: Caller Display Information Page
page item).
2. In the' Caller ID/Name' field corresponding to the desired port, enter the Caller ID
string (up to 18 characters).
3. From the 'Presentation' drop-down list, select one of the following:
• 'Allowed' [0]
• 'Restricted'
- sends the string defined in the 'Caller ID/Name' field when a Tel-to-
IP call is made using the corresponding device port.
[1]
4. Click the
- the string defined in the 'Caller ID/Name' field is not sent.
Submit
5. To save the changes to flash memory, refer to ''
button to save your changes.
Saving Configuration'' 167 on page .
Notes:
• When FXS ports receive 'Private' or 'Anonymous' strings in the From
header, they don't send the calling name or number to the Caller ID
display.
• If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is
used instead of the Caller ID name defined on this page.
• When the 'Presentation' field is set to 'Restricted', the Caller ID is sent to
the remote side using only the P-Asserted-Identity and P-Preferred-
Identity headers (AssertedIdMode).
•
• The value of the 'Presentation' field can be overridden by configuring the
'Presentation' field in the 'Source Number Manipulation' table (refer to
''
To maintain backward compatibility, when the strings ‘Private’ or
‘Anonymous’ are entered in the 'Caller ID/Name' field, the Caller ID is
restricted and the value in the 'Presentation' field is ignored.
Configuring the Number Manipulation Tables'' 124 on page ).
• You can also configure the Caller Display Information table using the ini
file table parameter CallerDisplayInfo.