3.1.6 Searching for Configuration Parameters
The Web interface provides a search engine that allows you to search any ini file parameter
that is configurable by the Web interface (i.e., has a corresponding Web parameter). You
can search for a specific parameter (e.g., "EnableIPSec") or a sub-string of that parameter
(e.g., "sec"). If you search for a sub-string, all parameters that contain the searched sub-
string in their names are listed.
To search for ini
1. On the Navigation bar, click the
file parameters configurable in the Web interface:
Search
2. In the 'Search' field, enter the parameter name or sub-string of the parameter name
that you want to search. If you have performed a previous search for such a
parameter, instead of entering the required string, you can use the 'Search History'
drop-down list to select the string (saved from a previous search).
tab; the Search engine appears in the
Navigation pane.
3. Click Search
Each searched result displays the following:
; a list of located parameters based on your search appears in the
Navigation pane.
• ini
• Link (in green) to its location (page) in the Web interface
file parameter name
• Brief description of the parameter
4. In the searched list, click the required parameter (link in green) to open the page in
which the parameter appears; the relevant page opens in the Work pane and the
searched parameter is highlighted for easy identification, as shown in the figure below:
Figure 3-13: Searched Result Screen
To Next Page
Loading...
