Version 5.8 85 September 2009
SIP User's Manual 3. Web-Based Management
3.3.3.6 Configuring the IPSec Table
The 'IPSec Table' page allows you to configure the Security Policy Database (SPD)
parameters for IP security (IPSec).
Note:
You can also configure the IPSec table using the ini file table parameter
IPSEC_SPD_TABLE (refer to ''Security Parameters'' 239 on page ).
To configure the IPSec SPD table:
1. Open the ‘IPSec Table’ page (Configuration tab > Security Settings menu > IPSec
Table
Figure 3-55: IPSec Table Page
page item).
2. From the ‘Policy Index’ drop-down list, select the rule you want to edit (up to 20 policy
rules can be configured).
3. Configure the IPSec SPD parameters according to the table below.
4. Click the button Create
5. To save the changes to flash memory, refer to ''
; the IPSec rule is applied on-the-fly to the device.
Saving Configuration'' 167 on page .
To Next Page
Loading...
