AudioCodes Media Pack MP-124 - 3.4.1.3 Maintenance Actions; 3.4.1.3.1 Resetting the Device

Version 5.8 165 September 2009
SIP User's Manual 3. Web-Based Management
3.4.1.3 Maintenance Actions
The 'Maintenance Actions' page allows you to perform the following operations:
 Reset the device (refer to ''Resetting the Device'' 165 on page )
 Lock and unlock the device (refer to ''Locking and Unlocking the Device'' 166 on page )
 Save the configuration to the device's flash memory (refer to ''Saving Configuration''
167
on
page )
 To access the 'Maintenance Actions' page:
 On the Navigation bar, click the Management tab, and then in the Navigation tree,
select the Management Configuration menu, and then choose the Maintenance
Actions
Figure 3-99: Maintenance Actions Page
page item.
3.4.1.3.1 Resetting the Device
The 'Maintenance Actions' page allows you to remotely reset the device. In addition, before
resetting the device, you can choose the following options:
 Save the device's current configuration to the device's flash memory (non-volatile).
 Perform a graceful shutdown, i.e., device reset starts only after a user-defined time
expires (i.e., timeout) or after no more active traffic exists (the earliest thereof).
 To reset the device:
1. Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' 164 on page ).
2. Under the 'Reset Configuration' group, from the 'Burn To FLASH' drop-down list, select
one of the following options:
• 'Yes': The device's current configuration is saved (burned
• 'No': Resets the device without saving the current configuration to flash (discards
all unsaved modifications).
) to the flash memory
prior to reset (default).