To navigate between Scenario Steps, you can perform one of the following:
In the Navigation tree, click the required Scenario Step.
In an opened Scenario Step (i.e., page appears in the Work pane), use the following
navigation buttons:
• Next:
•
opens the next Step listed in the Scenario.
Previous
: opens the previous Step listed in the Scenario.
Note: If you reset the device while in Scenario mode, after the device resets, you
are returned once again to the Scenario mode.
3.1.7.3 Editing a Scenario
You can modify a Scenario anytime by adding or removing Steps (i.e., pages) or
parameters, and changing the Scenario name and the Steps' names.
Note: Only users with access level of 'Security Administrator' can edit a Scenario.
To edit a Scenario:
1. On the Navigation bar, click the Scenarios
2. Click
tab; a message box appears, requesting
you to confirm Scenario loading.
OK
3. Click the
; the Scenario appears with its Steps in the Navigation tree.
Edit Scenario
4. You can perform the following edit operations:
button located at the bottom of the Navigation pane; the
'Scenario Name' and 'Step Name' fields appear.
•
a. On the Navigation bar, select the desired tab (i.e.,
Add Steps:
Configuration or
Management
b. In the Navigation tree, navigate to the desired page item; the corresponding
page opens in the Work pane.
); the tab's menu appears in the Navigation tree.
c. In the page, select the required parameters by marking the corresponding
check boxes.
d. Click Next
•
.
Add or Remove Parameters:
a. In the Navigation tree, select the required Step; the corresponding page
opens in the Work pane.
b. To add parameters, select the check boxes corresponding to the desired
parameters; to remove parameters, clear the check boxes corresponding to
the parameters that you want removed.
c. Click Next.
To Next Page
Loading...
