AudioCodes Media Pack MP-124 - 3.4.1.1.3 Configuring SNMP V3 Users

Version 5.8 161 September 2009
SIP User's Manual 3. Web-Based Management
5. To save the changes to flash memory, refer to ''Saving Configuration'' 167 on page .
Note: To delete a community string, select the Delete check box corresponding to
the community string that you want to delete, and then click Submit .
Table 3-29: SNMP Community Strings Parameters Description
Parameter Description
Community String
 Read Only [SNMPReadOnlyCommunityString_x]:
 Read / Write
Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
[SNMPReadWriteCommunityString_x]:
Trap Community String
Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
[SNMPTrapCommunityString]
3.4.1.1.3 Configuring SNMP V3 Users
The 'SNMP V3 Settings' page allows you to configure authentication and privacy for up to
10 SNMP v3 users.
 To configure the SNMP v3 users:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' 157 on page .
2. In the 'SNMP V3 Table' field, click the right-pointing arrow
button; the 'SNMP V3
Settings' page appears.
Figure 3-96: SNMP V3 Setting Page
3. To add an SNMP v3 user, in the 'Add' field, enter the desired row index, and then click
Add
4. Configure the SNMP V3 Setting parameters according to the table below.
. A new row appears.
5. Click the Apply
6. To save the changes, refer to ''
button to save your changes.
Saving Configuration'' 167 on page .
Notes:
• For a description of the web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' 37 on page .
• You can also configure SNMP v3 users using the ini file table parameter
SNMPUsers (refer to ''SNMP Parameters'' 249 on page ).