Notes:
• When a call release reason (defined in ''Configuring Reasons for
Alternative Routing'' 140 on page ) is received for a specific IP-to-Tel call,
an alternative Hunt Group for that call can be configured. This is
performed by assigning the call to an additional routing rule in the table
(i.e., repeat the same routing rule, but with a different Hunt
• For available notations representing multiple numbers/digits for
destination and source prefixes, refer to ''
Group ID).
Dialing Plan Notation for
Routing and Manipulation'' 377 on page .
• You can also configure the 'IP to Hunt Group Routing' table using the ini
file table parameter PSTNPrefix (refer to ''Number Manipulation and
Routing Parameters'' 328 on page ).
To configure the IP to Hunt
1. Open the 'IP to
Group Routing table:
Hunt Group Routing' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > IP to Trunk Group Routing
Figure 3-78: IP to Hunt Group Routing Page
page
item).
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the table according to the table below.
4. Click the Submit
5. To save the changes so they are available after a power failure, refer to ''
button to save your changes.
Saving
Configuration'' 167 on page .
Table 3-24: IP to Hunt Group Routing Table Description
Parameter Description
IP to Tel Routing Mode Determines whether to route IP calls to the
[RouteModeIP2Tel]
Hunt Group before or
after manipulation of destination number (configured in ''Configuring
the Number Manipulation Tables'' 124 on page ).
[0] Route calls before manipulation = IP-to-Tel calls are routed
before the number manipulation rules are applied (default).
To Next Page
Loading...
