3.4.1.2 Configuring the Regional Settings
The 'Regional Settings' page allows you to define and view the device's internal date and
time.
To configure the device's date and time:
1. Open the 'Regional Settings' page (Management tab > Management Configuration
menu > Regional Settings
Figure 3-98: Regional Settings Page
page item).
2. Enter the current date and time in the geographical location in which the device is
installed.
3. Click the Submit
button; the date and time are automatically updated.
Notes:
• If the device is configured to obtain the date and time from an SNTP
server (refer to ''Configuring the Application Settings'' 62 on page ), the
fields on this page are read-only and cannot be modified.
• For an explanation on SNTP, refer to ''Simple Network Time Protocol
Support'' 453 on page .
• After performing a hardware reset, the date and time are returned to their
defaults and therefore, should be updated.
To Next Page
Loading...
