Figure 9-18: Configuring Endpoint
5. In the 'Hunt Group Settings' page (refer to ''Configuring the Trunk Group Settings''
150
on
page ),
Figure 9-19: Configuring Hunt Groups
configure 'Per Account' registration for Hunt Group ID #1 and associate it
with IP Group #1; Configure 'Per Endpoint' registration for Hunt Group ID #2 and
associated it with IP Group #2.
6. In the 'Authentication' page (refer to “Configuring 142Authentication” on page ), for
channels 5-8 (i.e., Hunt Group ID #2), define for each channel the registration
Figure 9-20: Configuring Username and Password for Channels 5-8 in Authentication Page
(authentication) user name and password.
7. In the 'Account Table' page (refer to ''Configuring the Account Table'' 102 on page ),
configure a single Account for Hunt Group ID #1, including an authentication user
name and password, and enable registration for this Account to ITSP 1 (i.e., Serving
IP Group is 1)
Figure 9-21: Configuring Accounts
.
8. In the 'IP to Hunt Group Routing' page (refer to ''Configuring the IP to Trunk Group
Routing'' 135 on page ), configure that INVITEs with "ITSP1" as the hostname in the
From URI are routed to Hunt Group #1, and INVITEs with "ITSP2" as the hostname in
the From URI are routed to Hunt Group #2. In addition, configure calls received from
ITSP1 as associated with IP Group #1.
To Next Page
Loading...
