AudioCodes Media Pack MP-124 - Figure 3-35: IP Settings Page; Figure 3-36: Confirmation Message for Accessing the Multiple Interface Table; Figure 3-37: Multiple Interface Table Page

Version 5.8 59 September 2009
SIP User's Manual 3. Web-Based Management
 To configure the multiple IP interface table:
1. Open the 'IP Settings' page (Configuration tab > Network Settings menu > IP
Settings
Figure 3-35: IP Settings Page
>.
2. Under the 'Multiple Interface Settings' group, click the Multiple Interface Table
Figure 3-36: Confirmation Message for Accessing the Multiple Interface Table
button; a confirmation message box appears:
3.
Figure 3-37: Multiple Interface Table Page
Click OK to confirm; the 'Multiple Interface Table' page appears:
4. In the 'Add' field, enter the desired index number for the new interface, and then click
Add
5. Configure the interface according to the table below.
; the index row is added to the table.
6. Click the Apply button; the interface is added to the table and the Done
7. Click
button
appears.
Done
8. To save the changes to flash memory, refer to ''
to validate the interface. If the interface is not a valid (e.g., if it overlaps
with another interface in the table or it does not adhere to the other rules for adding
interfaces), a message is displayed to inform you and you must redefine your
interfaces accordingly.
Saving Configuration'' 167 on page .