AudioCodes Media Pack MP-124 - Figure 3-89: Hunt Group Settings; Table 3-27: Trunk Group Settings Parameters

Version 5.8 151 September 2009
SIP User's Manual 3. Web-Based Management
Note: You can also configure the Hunt Group Settings table using the ini file table
parameter TrunkGroupSettings (refer to ''Number Manipulation and Routing
Parameters'' 328 on page ).
 To configure the Hunt
1. Open the '
Group Settings table:
Hunt Group Settings' page (Configuration tab > Protocol Configuration
menu > Hunt Group submenu > Hunt Group Settings
Figure 3-89: Hunt Group Settings Page
page item).
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. Configure the Hunt
4. Click the
Group according to the table below.
Submit
5. To save the changes to flash memory, refer to ''
button to save your changes.
Saving Configuration'' 167 on page .
An example is shown below of a REGISTER message for registering endpoint "101" using registration
Per Endpoint mode. The "SipGroupName" in the request URI is taken from the IP Group table.
REGISTER sip:SipGroupName SIP/2.0
Via: SIP/2.0/UDP 10.33.37.78;branch=z9hG4bKac862428454
From: <sip:101@GatewayName>;tag=1c862422082
To: <sip:101@GatewayName>
Call-ID: 9907977062512000232825@10.33.37.78
CSeq: 3 REGISTER
Contact: <sip:101@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-Gateway-MP-118 FXS_FXO /v.5.40A.008.002
Content-Length: 0
Table 3-27: Trunk Group Settings Parameters
Parameter Description
Hunt Group ID The
[TrunkGroupSettings_Trunk
GroupId]
Hunt
Group ID that you want to configure.
The valid range is 1 to 99.