AudioCodes Media Pack MP-124 - Figure 3-112: Call Routing Status; Table 3-34: Call Routing Status Parameters; Viewing Call Routing Status; Viewing Registration Status

SIP User's Manual 184 Document #: LTRT-65412
MP-11x & MP-124
3.5.2.2 Viewing Call Routing Status
The 'Call Routing Status' page provides you with information on the current routing method
used by the device. This information includes the IP address and FQDN (if used) of the
Proxy server with which the device currently operates.
 To view the call routing status:
 Open the 'Call Routing Status' page (Status & Diagnostics tab > Gateway Statistics
menu > Calls Routing Status
Figure 3-112: Call Routing Status Page
page item).
Table 3-34: Call Routing Status Parameters
Parameter Description
 Proxy = Proxy server is used to route calls.
Current Call-Routing
Method
 Routing Table preferred to Proxy = The 'Tel to IP Routing' table takes
precedence over a Proxy for routing calls ('Prefer Routing Table'
parameter is set to 'Yes' as described in ''Configuring Proxy and
Registration Parameters'' 94 on page ).
 Not Used = Proxy server isn't defined.
Current Proxy
 IP address and FQDN (if exists) of the Proxy server with which the
device currently operates.
 N/A = Proxy server isn't defined.
Current Proxy State
 OK = Communication with the Proxy server is in order.
 Fail = No response from any of the defined Proxies.
3.5.2.3 Viewing Registration Status
The 'Registration Status' page displays whether the device or endpoints are registered to a
SIP Registrar/Proxy server.