AudioCodes Media Pack MP-124 - DNS Parameters; Table 6-7: DNS Parameters

SIP User's Manual 224 Document #: LTRT-65412
MP-11x & MP-124
6.1.7 DNS Parameters
The Domain name System (DNS) parameters are described in the table below.
Table 6-7: DNS Parameters
Parameter Description
Web: DNS Primary
Server IP
EMS: DNS Primary
Server
The IP address of the primary DNS server. Enter the IP address in
dotted-decimal notation, for example, 10.8.2.255.
[DNSPriServerIP]
Notes:
 For this parameter to take effect, a device reset is required.
 To use Fully Qualified Domain Names (FQDN) in the 'Tel to IP
Routing' table, you must define this parameter.
Web: DNS Secondary
Server IP
EMS: DNS Secondary
Server
The IP address of the second DNS server. Enter the IP address in
dotted-decimal notation, for example, 10.8.2.255.
[DNSSecServerIP]
Note:
For this parameter to take effect, a device reset is required.
Internal DNS Table
Internal DNS Table
This
[DNS2IP]
ini
[Dns2Ip]
FORMAT Dns2Ip_
file table parameter configures the internal DNS table for
resolving host names into IP addresses. Up to four different IP
addresses (in dotted-decimal notation) can be assigned to a host name.
The format of this parameter is as follows:
Index = Dns2Ip_DomainName,
Dns2Ip_FirstIpAddress, Dns2Ip_SecondIpAddress,
Dns2Ip_ThirdIpAddress, Dns2Ip_FourthIpAddress
For example:
Dns2Ip 0 = DnsName, 1.1.1.1, 2.2.2.2, 3.3.3.3, 4.4.4.4;
;
[\Dns2Ip]
 This parameter can include up to 20 indices.
Notes:
 If the internal DNS table is used, the device first attempts to resolve a
domain name using this table. If the domain name isn't found, the
device performs a DNS resolution using an external DNS server.
 To configure the internal DNS table using the Web interface and for a
description of the parameters in this ini file table parameter, refer to
''Configuring the Internal DNS Table'' 138 on page .
 For an explanation on using ini file table parameters, refer to ''Format
of ini File Table Parameters'' 191 on page .