AudioCodes Media Pack MP-124 - Page 325

Version 5.8 325 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
 This parameter is applicable to FXO and FXS interfaces,
but for FXO the Web interface does not display this
parameter.
Notes:
 It is possible to configure whether the KeyBlindTransfer
code is added as a prefix to the dialed destination number,
by using the parameter KeyBlindTransferAddPrefix (refer to
''Channel Parameters'' 344 on page ).
Activate
Keypad Feature - Call Waiting Parameters
Keypad sequence that activates the Call Waiting option. After
the sequence is pressed, a confirmation tone is heard.
[KeyCallWaiting]
Deactivate Keypad sequence that deactivates the Call Waiting option.
After the sequence is pressed, a confirmation tone is heard.
[KeyCallWaitingDeact]
Activate
Keypad Feature - Reject Anonymous Call Parameters
Keypad sequence that activates the reject anonymous call
option, whereby the device rejects incoming anonymous calls.
After the sequence is pressed, a confirmation tone is heard.
[KeyRejectAnonymousCall]
Deactivate Keypad sequence that de-activates the reject anonymous call
option. After the sequence is pressed, a confirmation tone is
heard.
[KeyRejectAnonymousCallDeact]
This [RejectAnonymousCallPerPort] ini
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable;
[\RejectAnonymousCallPerPort]
file table parameter determines whether the device
rejects incoming anonymous calls on FXS interfaces. The
format of this parameter is as follows:
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
For example:
[RejectAnonymousCallPerPort]
RejectAnonymousCallPerPort 0 = 0;
RejectAnonymousCallPerPort 1 = 1;
[\RejectAnonymousCallPerPort]
If enabled, when a device's FXS interface receives an
anonymous call, it responds with a 433 (Anonymity Disallowed)
SIP response.
 This parameter is applicable only to FXS interfaces.
Notes:
 This parameter is per device
 This parameter can appear up to
.
8 times for 8-port MP-11x
devices and up to 24 times for MP-124 devices
 The double dollar ($$) symbol represents the default value.
.
 For an explanation on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' 191 on page .