AudioCodes Media Pack MP-124 - Page 329

Version 5.8 329 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
 For a description of ini file table parameters, refer to ''Format
of ini File Table Parameters'' 191 on page .
Hunt Group Settings Table
This [TrunkGroupSettings] ini file table parameter defines rules for port allocation per
Hunt
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_
Group. If no rule exists, the global rule defined by the
parameter ChannelSelectMode takes effect. The format of this
parameter is as follows:
Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_Cont
actUser, TrunkGroupSettings_ServingIPGroup
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 1, 0, 5, audiocodes, user, 1;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2;
[\TrunkGroupSettings]
;
[\TrunkGroupSettings]
 This parameter can include up to 24 indices.
Notes:
 For configuring Hunt Group Settings using the Web interface,
refer to ''Configuring Trunk Group Settings'' 150 on page .
 For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters'' 191 on page .
Web: Channel Select Mode
EMS: Channel Selection Mode
Port (channel) allocation algorithm for IP-to-Tel calls.
[ChannelSelectMode]
 [0] By Dest Phone Number = Selects the device's channel
according to the called number (defined in the 'Endpoint
Phone Number' table -- Configuring the Endpoint Phone
Numbers on page 149)

. (default.)
[1] Cyclic Ascending = Selects the next available channel in
an ascending cyclic order. Always selects the next higher
channel number in the hunt group. When the device reaches
the highest channel number in the hunt group, it selects the
lowest channel number in the hunt

group and then starts
ascending again.
[2] Ascending = Selects the lowest available channel. It
always starts at the lowest channel number in the hunt

group
and if that channel is not available, selects the next higher
channel.
[3] Cyclic Descending = Selects the next available channel in
descending cyclic order. Always selects the next lower
channel number in the hunt group. When the device reaches
the lowest channel number in the hunt group, it selects the
highest channel number in the hunt

group and then starts
descending again.
[4] Descending = Selects the highest available channel.
Always starts at the highest channel number in the hunt
group and if that channel is not available, selects the next