CVLAN and DLG System Administration
4-78 Issue 3 May 2002
Use this screen as follows:
■To change the port’s CV/LAN service state:
1. Press or use the arrow keys to move to the desired port.
2. Press to toggle the Service State.
NOTE:
Busying a port out causes that port’s TCP connection (if one
exists) to be closed. No new connections are permitted on that
port until the port is placed back in service.
3. The following prompt appears: Are you sure? (Y/N). Type Y
and press . The CV/LAN Port Status/Control screen
reappears showing the changed state.
If you type N and press , the CV/LAN Port Status/Control
screen immediately reappears.
The DEFINITY
system Port State
(continued)
■BUSIEDOUT — The BRI Port is administered on the
DEFINITY system but has been busied out in the BRI
driver on the MAPD.
■SW INTF DN — The DEFINITY system interface
(angel) is down.
■SW INTF DN BSY — The DEFINITY system
interface (angel) is down and the BRI Port has been
busied out in the BRI driver on the MAPD.
Number of Client
Connections
Read-only. Number of currently connected clients.
CV/LAN Service
State
Either in service or out of service.
Messages to the
DEFINITY system
Read-only. The number of messages sent to the
DEFINITY system in the last message collection period.
Messages from
the DEFINITY
system
Read-only. The number of messages sent by the
DEFINITY system in the last message collection period.
Message Period The time period (in minutes) during which messages are
sent and received. This is a per port number. Default =
30.
Field Name Description
TAB
STATE
RETURN
To Next Page
Loading...
Need help?
General
