Installation: Task 5 — Connect the Maintenance Modem
Issue 3 May 2002
2-35
Installation: Task 5 — Connect
the Maintenance Modem
For this task, make sure you have the correct ED1E434-11G311 cable (in a length
between 5 and 50 feet). Refer to Figure 2-17 (ignore the shaded areas) as you
complete this task.
Figure 2-17. Connecting the Maintenance Modem
1. Physically connect one end of the cable to the modem and the other end to
the MAPD maintenance port (Maint/Port A).
2. Set the modem options as per "Modem Option Settings" in Appendix B,
and if necessary, connect the modem to a phone jack and power on.
Group 311 Cable
Maint/Port A
RJ45 to LAN
DCIU (Reserved for future use)
Switch
MAPD
Cable
MAPD
Board
Modem
Dial-up
Terminal
Modem
Tip/
Ring
Optional
RS232
Group 311
Cable
Modem*
Tip/
Ring
Avaya Remote Access
Modem must be nongrounded
! CAUTION:
*
isolated from the ground).
(that is, the modem must be
External
Printer
H600-258-1
Null Modem
Group 311 Cable
DTE CONNECTION
Dial-up
Terminal
RS232
ADMIN/PORT B
DCE CONNECTION
DCE port on 715 BCT
Modem
To Next Page
Loading...
