Avaya


Definity User Manual

Installation: Task 1 — Gathering the Required Tools
Issue 3 May 2002
2-13
Installation: Task 1 — Gathering the
Required Tools
To install a MAPD system, you need the following tools:
■ Narrow width, flat-blade screwdriver
■ Antistatic grounded wrist strap
■ Punch-down tool
Installation: Task 2 — Reviewing the
Safety Guidelines
Always follow these precautions whenever working with electronic equipment.
!
WARNING:
Electronic equipment can be damaged by electrostatic discharge. Do not
touch any electronic component unless you are properly grounded.
!
DANGER:
Do not touch the switch backplane while installing the MAPD system. The
backplane contains dangerous voltage and current.
To prevent damage to the equipment and yourself, follow these guidelines:
■ Make sure you are familiar with the procedures necessary to prevent
electrostatic damage to the equipment.
■ Properly ground a wrist strap.
■ Place the grounded wrist strap on your bare wrist. (The wrist strap must
contact your bare skin directly — do not wear it over your clothes.)
■ Do not remove the system assembly from the polyethylene bag until:
— Your wrist strap is on your wrist and properly grounded.
— You have made room in the switch carrier and you are ready to
insert the system assembly in the carrier.
— The system assembly adapter cable is appropriately connected to
the back of the switch (see Task 5, Step 2 in the section,
‘‘Installation: Task 3 — Installing the MAPD Assembly in the Switch,’’
in this chapter).
If you need to work on the system assembly — that is, disassemble it — place the
assembly on a grounded antistatic work mat.

Avaya


Definity Specifications

General

Brand	Avaya
Model	  Definity
Category	Server
Language	English