Installing the MAPD
2-34 Issue 3 May 2002
8. Set the options on the terminal and modem. Refer to Appendix B,
‘‘Terminal and Modem Option Settings,’’ for a list of option settings for all
supported terminals and modems.
NOTE:
When installing a serial printer on all but a 610 or 615 BCT, set
the options on the printer as described in the manual supplied
with the printer, then set the corresponding options on the
terminal to match. On the 610/615, set the terminal options
first, and then set the printer options.
9. At the terminal, enter AT. If the modem is installed correctly, it responds
with “OK” (written on the terminal screen).
10. Enter ATDT and the telephone number of the modem connected to the
MAPD system Admin port (listed in Appendix B).
■ If the terminal is installed correctly (and the MAPD system is in
either ASAI or AINIT state), the screen displays the login prompt.
■ If the terminal does not display the login prompt when the MAPD
system is in one of the above states, try pressing Return a few
times. If the login prompt still does not appear, write down the state
displayed on the LCD, and then see the procedure for terminal
connections in Appendix D, ‘‘Troubleshooting Procedure.’’
11. Log in to the MAPD system (see Chapter 3,). If you can log in successfully,
the modem and terminal options are set correctly.
To Next Page
Loading...
Need help?
General
