Avaya S8700 - Page 10

10
Installing the Avaya S8700 Media Server with G600 Media Gateway
October 2002
Install the Battery Mounting/Wiring 179
Install the Expanded Power Distribution Unit 180
Power Up and Test the Power Supply 181
Wire the 1146B2 Power Distribution Unit 181
Reset LEDs on Power Distribution Unit 182
1151A1 and 1151A2 Power Supplies 183
Important Safety Instructions for 1151A1 and
1151A2 Power Supplies 183
Using 1151A1 and 1151A2 Power Supplies 184
Connect the 1151A1 or 1151A2 Power Supplies 184
P333T-PWR Power over Ethernet Stackable Switch 185
P333T-PWR switch Important Safety Instructions 185
Using the P333T-PWR switch 186
Connect the P333T-PWR switch 187
• Completing the Installation Administration 189
Verify translations 189
View alarms 189
Upgrade the IPSI firmware (if necessary) 190
Enable and disable Ethernet switch ports 190
Back up the media server to PCMCIA flashcard 191
Release busied out media server 192
View alarms 192
Add INADS phone numbers 193
Enable alarms to INADS via modem 193
Enable alarms to INADS via SNMP 193
Register the system 194
• Accessing the Avaya S8700 Media Server 195
Accessing the Avaya S8700 Media Server Directly 195
Media Server Web Interface 196
Avaya Site Administration 197
Command Line Interface 197
Accessing the Avaya S8700 Media Server
Remotely over the Network 197
Accessing the Avaya S8700 Media Server
Remotely over a Modem 198
Setting up a dial-up connection 198
Dialing up to the media server 198
Finding the active media server IP address 199