59
Installing the Avaya G600 Media Gateway
October 2002
Perform these tasks to install the Avaya G600 port network:
• ‘‘Check and Inspect the Order’’ on page 59
• ‘‘Set the Carrier Address ID’’ on page 63
• ‘‘Mount the Avaya G600 Media Gateway in the Rack’’ on page 64
• ‘‘Cabling the G600 Media Gateways’’ on page 79
Check and Inspect the Order
Perform these tasks before you begin the installation:
• ‘‘Check Customer’s Order’’ on page 59
• ‘‘Unpack and Inspect the Avaya G600 Media Gateway’’ on page 59
• ‘‘Check Circuit Packs’’ on page 61
• ‘‘Correct Shipping Errors’’ on page 63
Check Customer’s Order
1 Check the customer’s order and the shipping packing lists to confirm that all equipment
is included.
2 Check the system adjuncts for damage and report all damage according to local shipping
instructions.
3 If any equipment is missing, report the information to your Avaya representative.
Unpack and Inspect the Avaya G600 Media
Gateway
!
DANGER:
Use lifting precautions. An empty Avaya G600 Media Gateway weighs 35–39 pounds
(16–18 kilograms).
1 Unpack the media gateway and remove all packing material.
2 Verify the equipment received. See ‘‘Equipment packed with a single media gateway’’
on page 60. Actual equipment may vary in appearance and may ship in separate
packages. Equipment comcodes are listed in ‘‘Comcodes for equipment used with Avaya
G600’’ on page 61.
NOTE:
The Avaya G600 power cord, software and documentation CDs, wrist strap, mounting
screw kit, mounting template, and media gateway feet are shipped inside the media
gateway accessory compartment. See ‘‘Equipment packed with a single media gateway’’
on page 60.
The optional G600 media gateways for port hardware only are shipped with AC power
cord or international power cord kit, mounting screw kits, TDM/LAN bus cable, EMI
To Next Page
Loading...
