Avaya S8700 - Add INADS Phone Numbers; Enable Alarms to INADS Via Modem; Enable Alarms to INADS Via SNMP

193
Completing the Installation Administration
October 2002
Add INADS phone numbers
NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft.
4 At the prompt type almcall -f 9,18005353573
5 If alarms will be reported to a second number type almcall -s second-number and press
Enter.
6 At the prompt type almcall and press Enter. Verify that the proper information has been
entered.
Enable alarms to INADS via modem
NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft.
4 At the prompt type almenable -d b and press Enter.
5 Type almenable and press Enter to verify that the alarms are enabled.
6 Log off.
Enable alarms to INADS via SNMP
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device see (Avaya personnel only): http://135.8.11.4/team-sra/
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft.