Avaya S8700 - Verify Media Server 2 Connection to Customers LAN (if Provided); Update System

41
Configure Media Server 2
October 2002
• Set DNS/DHCP
• Set Static Routes
• Configure Time Server
• Set Modem Interface
• Update System
Update System
1 When the Update System page displays, click Continue to update the server.
NOTE:
The media server is not configured until you click Continue on the Update System page.
The Update System screen displays each configuration task as it completes it. The last
line says "System modifications completed."
Verify Media Server 2 Connection to Customer’s
LAN (if provided)
The following administration uses the services laptop computer connected to media server 1
and uses the media server Web interface.
Refer to the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server for information on how to access a computer on the customer’s network.
1 Connect a customer-supplied CAT5 straight-through cable from media server 2, port 1
(Eth0), to the customer’s LAN. Refer to Getting Started with the Avaya™ S8700 Media
Server with G600 Media Gateway.
NOTE:
For security reasons, you may not be able to ping out to the customer’s network. If you are
not able to, look at the LAN security settings, particularly icmp.
2 Under Security click Set LAN Security
3 If icmp is not checked, check both boxes to the left and click Set Security.