51
Customizing the Active Media Server
October 2002
Customizing the Active Media
Server
Use Avaya Site Administration to administer the media server using the MultiVantage software.
If you do not have Avaya Site Administration 1.11 on your computer or laptop, you must
download it from the media server and install it.
NOTE:
You must use Avaya Site Administration 1.11 or higher to be able to administer new
features in Release 1.1 or higher Avaya MultiVantage Software.
List of Tasks:
• ‘‘Set up Avaya Site Administration’’ on page 51
• ‘‘Starting Avaya Site Administration’’ on page 52
• ‘‘Input Translations’’ on page 53
• ‘‘Reset Media Server’’ on page 53
• ‘‘Add Media Gateways’’ on page 53
• ‘‘Administer and Enable the IP Media Server Interface’’ on page 54
• ‘‘Add IPSI Translations to MultiVantage Software’’ on page 55
Set up Avaya Site Administration
You can set up Avaya Site Administration one of two ways:
• ‘‘Directly through a dedicated services port’’ on page 51
• ‘‘Remotely over the network’’ on page 52
Directly through a dedicated services port
The following administration is done on a computer used to access the active media server.
1 Plug the services laptop into the dedicated services port (default is 2 [Eth1]) on the back
of the active media server.
2 Under Telephony Administration click Download ASA to download Avaya Site
Administration l.11 to your computer.
3 Follow the steps in the Setup wizard to install ASA on your computer.
NOTE:
The following procedure establishes a record for use when connected to the dedicated
Avaya services port. If this record already exists (from a previous installation) this
procedure is not required.
4 On your computer launch Avaya Site Administration
To Next Page
Loading...
