129
Connecting to the Customer’s Network
October 2002
Administer the TN2501AP
After you have installed the hardware, to support an FTP session you must administer and test
the installation.
Use Avaya Site Administration for this administration.
Verify circuit pack location
1 Type list configuration board board-location and press Enter.
The System Configuration report appears. Use this report to ensure that the MultiVantage
software recognizes the TN2501AP circuit pack after it is latched in the carrier slot.
2 Verify the following field values:
• Board Type shows VAL-ANNOUNCEMENT
• Code is TN2501AP
Administer the node names
1 Type change node-names ip and press Enter.
The IP Node Names screen appears. Use this screen to administer the circuit pack’s node
name.
list configuration board 1c08 page 1
SYSTEM CONFIGURATION
Board Assigned Ports
Number Board Type Code Vintage u=unassigned t=tti p=psa
01C08 VAL-ANNOUNCEMENT TN2501AP HW00 FW001 01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
U
Command successfully completed
To Next Page
Loading...
