120
Connecting to the Customer’s Network
October 2002
TN2302AP Amphenol Adapter
Connect the Ethernet
1 Connect the network cable(s) to the ETHERNET connector on the TN2302AP backplane
adapter(s). Refer to ‘‘TN2302AP Amphenol Adapter’’ on page 120
.
NOTE:
You need a CAT5 or better cable for 100-Mbps operation.
Install the circuit packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN2302AP circuit packs are hot-swappable, so you do not need to power down the
media gateway to install them.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
1 Insert the TN2302AP IP Media Processor into the port slot you reserved for it and seat it
properly (See ‘‘TN2302AP IP Interface faceplate’’ on page 121
).
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The
RED LED stays on until an IP address is assigned to the circuit pack.
Figure notes
1 Amphenol connector to backplane
connector corresponding to
TN2302AP slot
2 To network
3 9-pin connector for
maintenance
addfipm2 KLC 083000
1
2
3
To Next Page
Loading...
