Avaya S8700 - Check Your Shipment; Install a TN799 DP C-LAN; Install the Cables

113
Connecting to the Customer’s Network
October 2002
Check your shipment
When the order arrives at your site, check the contents (see ‘‘Required Hardware’’ on page
113).
1 Inspect the shipping carton for damage before opening it. If the box is damaged, do not
open it. Inform the shipping company, and ask for instructions on filing a claim.
2 If the box is undamaged, check the contents against the packing slip. Check the condition
of each component, and note any damage or shortages on the packing slip. The carton
should contain the items in ‘‘Required Hardware’’ on page 113
for each TN799DP
C-LAN circuit pack ordered.
3 Read and follow any directions inserted into the package by the factory.
Install a TN799DP C-LAN
Have the following equipment on site:
• An unoccupied port slot for the TN799DP.
• A 10 BaseT Ethernet connection into your LAN for the TN799DP.
• One or more valid, unused IP addresses on the network (one for each TN799DP C-LAN)
that can be assigned to the C-LAN circuit pack. You also need the subnet mask and
default gateway.
NOTE:
Get this information from the network administrator or refer to the filled-out job aid
entitled Pre-Installation Network Planning Forms—S8700 Media Server.
• A 259A adapter for each TN799DP.
• A CAT3 or CAT5 cable with a DW8 connector on each end.
Install the cables
1 Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the media gateway:
2 Connect a 259A connector to the Amphenol connector corresponding to each TN799DP
slot. See ‘‘Cable Connection for C-LAN’’ on page 114
. For a pinout of TN799DP, see
‘‘TN799DP Pinout’’ on page 114
.
Required Hardware
Comcode/Code Description Quantity
108525528 TN799DP Control LAN circuit pack 1 or more
102631413 ADPTR-259A Adapter
1
1/C-LAN
1
The adapter has an amphenol connector on one side and an RJ45 connector on the other
for connecting to the network.