Avaya S8700 - Completing the Installation Administration; Verify Translations; View Alarms

189
Completing the Installation Administration
October 2002
Completing the Installation
Administration
This section covers the following tasks:
• ‘‘Verify translations’’ on page 189
• ‘‘View alarms’’ on page 189
• ‘‘Upgrade the IPSI firmware (if necessary)’’ on page 190
• ‘‘Enable and disable Ethernet switch ports’’ on page 190
• ‘‘Back up the media server to PCMCIA flashcard’’ on page 191
• ‘‘Release busied out media server’’ on page 192
• ‘‘View alarms’’ on page 192
• ‘‘Add INADS phone numbers’’ on page 193
• ‘‘Enable alarms to INADS via modem’’ on page 193
• ‘‘Register the system’’ on page 194
Verify translations
The following administration is done on a computer used to access the Avaya S8700 Media
Server using Avaya Site Administration.
1 Type list configuration all and press Enter to view all the administered circuit packs in
the system.
2 Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3 Check the administration status on the following items:
• list station
• list trunk-group
• list hunt-group
View alarms
The following administration is done on a computer used to access the active media server
using the media server Web interface.