218
Testing the Complete Configuration
October 2002
LEDs on Powerware 9125 UPS
After plugging the UPS in, all the LEDs flash briefly. After a self test, the Normal mode LED
flashes, indicating that the UPS is in Standby mode.
For more information on the LEDs, refer to the UPS user’s guide that comes with the
Powerware 9125 UPS.
Telephone Console LEDS
Telephones and attendant consoles have some alarm LEDs that must be checked out.
Attendant Console LEDs
The console has 2 red LEDs, labeled “ALM” and “ACK”. The ALM LED lights steadily when
there is a major or minor alarm at the media server. The ACK LED lights steadily if the alarm
has been successfully reported to INADS. If the media server is unable to report the alarm to
INADS, the LED flashes; this signals the attendant to call INADS and report the alarm.
Figure notes
1 Normal mode indicator
2 Battery mode indicator
3 Bypass mode indicator
4 Test/Alarm reset button
5 Off button
6 On button
7 Bar graph indicators
8 Alarm indicators
1
2
3
4 5
6
7
8
ledlups KLC 030102
To Next Page
Loading...
