54
Customizing the Active Media Server
October 2002
2 Fill in the location and carrier type for media gateways 2, 3, and 4.
Administer and Enable the IP Media Server
Interface
NOTE:
Do this procedure only if the translations were not input earlier.
The following administration uses the services laptop computer connected to the active media
server and uses Avaya Site Administration.
NOTE:
This procedure enables the IPSI circuit packs and allows them to control the port
networks.
1 Type change system-parameters ipserver-interface and press Enter.
2 Verify that the Primary Control Subnet Address is correct.
add cabinet 1 Page 1 of 1
CABINET
CABINET DESCRIPTION
Cabinet: 1
Cabinet Layout: rack-mount-stack
Cabinet Type: expansion-portnetwork
Location: 1
Room: Floor: Building:
CARRIER DESCRIPTION
Carrier Carrier Type Number
D not-used
C not-used
B not-used
A rmc-port
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix:
Primary Control Subnet Address: 172. 22. 0. 0*
Secondary Control Subnet Address: . . .
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled
NOTE: * indicates data changed on the server
To Next Page
Loading...
