Avaya S8700 - Connect the Ethernet Switch Cables to the IPSI Circuit Packs; Verify Connectivity to Media Servers

108
Connecting the Hardware
October 2002
LED display showing that the IPSI has a static IP address
15 Disconnect the laptop from the faceplate.
NOTE:
If necessary, use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
16 Repeat for each IPSI circuit pack.
Connect the Ethernet Switch Cables to the IPSI
Circuit Packs
Connect one end of the GREEN CAT5 straight-through cable to the Ethernet switch and the
other to the IPSI adapter on the back of media gateway A. For a connectivity guide refer to
Getting Started with the Avaya™ S8700 Media Server with G600 Media Gateway
or
Getting Started with the Avaya™ S8700 Media Server with MCC1 or SCC1 Media
Gateway .
Verify Connectivity to Media Servers
The following administration is done on a computer used to access the active media server
using the media server Web interface.
NOTE:
We recommend you be on the active media server.
1 Under Diagnostics click Execute Pingall and select "Other server(s), All IPSIs, UPS(s),
Ethernet switches." to verify connectivity to these units.
CLK
S
E
R
V
fpdlled1 LJK 022502