Avaya S8700 - Port Network (S8700 Multi-Connect Only); Test Expansion Interface Exchange for each

207
Testing the Complete Configuration
October 2002
1 Type test tdm port-network 1 and press Enter.
2 Verify a test results screen similar to "Sample Test Results for TDM Bus Port Network 1"
is displayed.
3 If result is FAIL for any test, check the connectors of the TDM bus cables in PN 2.
4 Repeat these steps for each PN to check the TDM bus cables.
Sample Test Results for TDM Bus Port Network 1
Test Expansion Interface Exchange for Each
Port Network (S8700 Multi-Connect only)
If the configuration is critical reliability, test the expansion interface exchange for each Port
Network (PN).
1 Type status port-network number <1-64> and press Enter.
This displays the standby expansion link. See "Sample of Port Network Status before
Expansion Link is Set—S8700 Multi-Connect".
2 Type set expansion-link UUCSS, where UUCSS is one of the cabinet, carrier, and port
locations of the standby expansion link, and press
Enter.
3 Verify the bottom of the screen displays:
Command successfully completed
4 Type status port-network number <1-64> and press Enter.
A screen similar to "Sample of Port Network Status after Expansion Link is Set—S8700
Multi-Connect" displays.
5 Verify that the MODEs of the expansion links have changed.
6 If any problems are indicated, check the TDM cables and the inter-cabinet cables (ICC)
in the associated port network.
test tdm port-network 1
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
PN 01A TDM-BUS 294 PASS
PN 01A TDM-BUS 296 PASS
PN 01A TDM-BUS 297 ABORT 1005
PN 01B TDM-BUS 294 PASS
PN 01B TDM-BUS 296 ABORT 1005
PN 01B TDM-BUS 297 PASS