22
Configuring the Hardware in the Rack
October 2002
Configuring the Hardware in the
Rack
After you have installed all the hardware in the rack, you must configure the components and
connect them together.
This section covers the following tasks:
• ‘‘Configure Media Server 1’’ on page 23
• ‘‘Connect Duplication Cables’’ on page 37
• ‘‘Configure Media Server 2’’ on page 37
• ‘‘Connect UPS Ethernet Cables to Ethernet Switch’’ on page 44
• ‘‘Configure the UPSs’’ on page 45
• ‘‘Configure the Avaya Ethernet Switch (if used)’’ on page 49
Once the hardware is installed you must upgrade the software on the two media servers,
configure them, install the license and Avaya authentication files, and test the connectivity to
the customer’s LAN. You upgrade and configure the first media server, verify its operation, then
upgrade and configure the second media server and verify its operation.
To Next Page
Loading...
