Avaya S8700 - Digital Tie Trunk Example

141
Installing and Wiring Telephones
October 2002
3 Install cross-connect jumpers to connect the pins from the tie trunk circuit pack to the
appropriate leads on the external tie trunk.
4 ‘‘Analog Tie Trunk Wiring’’ on page 141 shows a media gateway tie trunk connected to
another media gateway tie trunk. Names of the tie trunk leads must be determined from
the manufacturer or supplier of the external trunk circuit.
5 Administer on the Trunk Group screen on Avaya Site Administration. Refer to the
Administrator’s Guide for Avaya MultiVantage Software for more details.
Analog Tie Trunk Wiring
Digital Tie Trunk Example
This example shows how to connect digital tie trunk wiring from one media gateway to another
one or any other Avaya configuration. ‘‘Digital Tie Trunk Wiring’’ on page 142
shows the
connections.
1 Install cross-connect jumpers to connect the pins from the digital trunk circuit pack to
appropriate pins on the manufacturer’s or supplier’s external digital trunk.
2 Set option switches on the port circuit pack (Digital Trunk).
3 Refer to the Job Aid entitled Option Switch Settings for detailed information.
4 Administer on the DS1 and Trunk Group screens through ASA. Refer to the
Administrator’s Guide for Avaya MultiVantage Software for more details.
Figure notes
1 External Trunk or Adapter 2 Tie Trunk Circuit Pack (Position 1C05)
tie
_
wire RBP 071796
1
27
26
29
4
30
5
2
28
3
31
6
T.1
R.1
T1.1
R1.1
E.1
M.1
T. 2
R.2
T1.2
R1.2
E.2
M.2