105
Connecting the Hardware
October 2002
Connecting the Hardware
This section covers the following tasks:
• ‘‘Set IPSI Static IP Addresses’’ on page 105
• ‘‘Connect the Ethernet Switch Cables to the IPSI Circuit Packs’’ on page 108
• ‘‘Verify Connectivity to Media Servers’’ on page 108
• ‘‘Verify IPSI firmware version’’ on page 109
• ‘‘Enable control of IPSIs’’ on page 109
• ‘‘Verify License Status’’ on page 109
• ‘‘Connect the USB Modems’’ on page 109
Set IPSI Static IP Addresses
For IP Connect Configurations the IPSI circuit packs get static IP addresses, which are
adminstered directly through the Ethernet port connection on the IPSI faceplate (top port). See
‘‘Connecting directly to the IPSI’’ on page 105
.
Connecting directly to the IPSI
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
