199
Accessing the Avaya S8700 Media Server
October 2002
1 When prompted, enter your remote access login name and password.
2 When the "Start PPP now!" message appears, click Done. When you see the Connection
Complete dialog box, your computer is connected to the media server.
3 To use Avaya Site Administration, launch the software and select the switch you want to
dial into. Refer to ‘‘Installing Avaya Site Administration’’ on page 199
for information
on installing the software and build a record for a particular media server.
4 To open a Telnet session, click Start > Run to open the Run dialog box. Type telnet
IPaddress, where IPaddress is the address of the actual active media server.
Finding the active media server IP address
1 To get the IP address of the actual active media server, go to the task bar at the bottom
right of your PC screen.
2 Right-click on the Network Status icon, and select Status, then the Details tab.
3 Scroll down until you see the Server IP address. This is the IP address for the media
server you are connected to.l
Installing Avaya Site Administration
If you do not have Avaya Site Administration on your computer, make sure your PC or laptop
first meets the minimum requirements described in ‘‘Minimum requirements to run Avaya Site
Administration’’ on page 199:
Minimum requirements to run Avaya Site Administration
Operating systems
MS Windows 95
MS Windows 98
MS Windows NT 4.0
MS Windows 2000
MS Windows XP/ME
Processor/RAM
486SL/66/16 MB
Pentium/32 MB
Pentium/64 MB
Pentium-class 300 MHz/64 MB
Pentium-class 3, 600 MHz/256 MB
Graphics adapter SVGA with minimum screen resolution of 800 x 600
Floppy disk drive 3-1/2 in. 1.44-MB floppy disk drive
CD-ROM CD-ROM drive (required to install Avaya Site
Administration from CD)
Available hard disk space A minimum of 100-MB free hard disk space is required.
The requirement for disk space depends on the size and
number of configuration data sets.
To Next Page
Loading...
