23
Configure Media Server 1
October 2002
Configure Media Server 1
You must configure each media server in turn. This section covers the following tasks:
• ‘‘Connect and log into the S8700 media server Web Interface’’ on page 24
• ‘‘Verify Software Version’’ on page 26
• ‘‘Set media server configuration type’’ on page 27
• ‘‘Continue Server 1 configuration’’ on page 28
• ‘‘Install License and Avaya Authentication Files’’ on page 30
• ‘‘Verify Media Server 1 Connection to Customer’s LAN (if provided)’’ on page 31
• ‘‘Test Media Server 1 LEDs’’ on page 33
• ‘‘Configure SNMP Traps’’ on page 34
The following administration uses the services laptop computer and the media server Web
interface. Connect the services laptop computer to the dedicated services port (default is port 2
[Eth1]) on the back of the media servers using the black crossover cable.
NOTE:
Make sure you have the filled-out job aid entitled Pre-Installation Network Planning
Forms—S8700 Media Server before beginning this process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to the job aid
entitled Pre-Installation Information—S8700 Media Server
.
Power up media server 1
1 Plug the AC power cord for media server 1 into UPS 1 to power it up. Refer to Getting
Started with the Avaya™ S8700 Media Server with G600 Media Gateway.
Set product ID
You must assign a product ID number to the configuration. You can obtain this product ID
number from the Automatic Registration Tool (ART) script.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft.
4 At the prompt type productid -p number and press Enter.
5 Log off.
To Next Page
Loading...
