Avaya S8700 - Test the External Connection to the LAN

116
Connecting to the Customer’s Network
October 2002
.
7 Type in the following information:
NOTE:
Enable the Ethernet port last, after you have filled in the information in the other fields.
• Set Slot field to UUCSS, where UUCSS is the cabinet, carrier, and slot.
• The Code and SFX fields are automatically populated with TN799DP.
• In the Node Name field type the same node name entered on the Node Name
screen.
• In the Subnet Mask field use the default setting unless you are given a different
subnet mask.
• In the Gateway Address field use the address you are given or leave blank.
• Set the Net Region field to 1 unless you are given a different number.
• Set the Enable Eth Pt field to y
8 Press Enter to save the information and effect the new settings.
Refer to the Administration for Network Connectivity for Avaya MultiVantage Software for
more information on these administration steps and for the steps to administer IP Softphones
and H.323 trunks.
Test the External Connection to the LAN
To test the external IP connections, ping the C-LAN and ping a known computer connected to
the network. If everything is configured correctly, the Result column on the Ping Results
screen reads pass. If it reads abort, verify the IP-address information and check the
connectivity, including the cabling.
change ip-interfaces Page 1 of 15
IP INTERFACES
Enable Net
Eth Pt Type Slot Code Sfx Node Name Subnet Mask Gateway Address Rgn
y C-LAN 05B11 TN799 C sr1clan2 255.255.248.0 172.16 .23 .254 3
y C-LAN 01A11 TN799 C traf-clan 255.255.248.0 172.16 .23 .254 2
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .