Avaya S8700 - Add IPSI Translations to Multivantage Software

55
Customizing the Active Media Server
October 2002
The subnet address must match the most significant 3 octets (the first 3 groups of digits
in the subnet address) of the Server IP address filled in on the control network entry from
the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server.
An Asterisk (*) to the right of the Subnet Address field means that although a subnet
address is displayed, it is not the correct one; the Avaya MultiVantage call processing
software does not have the subnet information. After verifying the displayed
information, submit this form with or without changes to update the Avaya MultiVantage
software with the correct subnet information.
!
CAUTION:
If the information displayed in the Primary and/or Secondary Subnet Address fields is not
correct it must be changed on the media servers. Use the Configure Server entry on the
Web Interface application to change the media server configuration. Then return here to
perform this step.
3 Set the Switch Identifier: field to the switch ID letter (A thru J; A is the default
setting).
4 Set the IPSI Control of Port Networks: field to enabled.
5 Press Enter to effect the change.
Add IPSI Translations to MultiVantage Software
NOTE:
The information you provide differs, depending whether the IPSIs get static addresses or
they are assigned automatically through DHCP.
1 Type add ipserver-interface PNnumber and press Enter to add the IPSI circuit pack
information.
2 When using static addressing, in the Host: field, type in the IP address for the IPSI in
the port network listed in the Location: field.
Verify that all the other fields are populated.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
Socket Encryption? y
Enable QoS? y
Primary IPSI QoS Parameters
------------ --------------
Location: 8A02 Call Control 802.1p: 6
Host: 192.168.18.40 Call Control DiffServ: 46
DHCP ID: ipsi-A08a