Avaya S8700 - Test Media Server 2 Leds

42
Configure Media Server 2
October 2002
4 Under Diagnostics click Execute Ping.
5 Type in the IP address of a computer on the network.
6 Click Execute Ping.
7 Verify that the ping was successful, indicating that the media server is connected to the
customer’s network.
8 Type in the host name, if DNS is administered, of a computer on the network.
9 Click Execute Ping.
10 Verify that the ping was successful, indicating that DNS is working.
If available, have a customer representative do the following test from a computer on their
network:
11 Click Start > Run to open the Run dialog box.
12 Type command to open an MS-DOS command window.
13 Type ping server2name, where server2name is the host name of media server 2, if DNS
is administered.
14 Verify that the ping was successful.
15 Type ping server2ipaddress, where server2ipaddress is the IP address of media server 2.
16 Verify that the ping was successful.
17 If you checked icmp earlier (it was not a default setting), uncheck both boxes to the left
of it and click Set Security.
Test Media Server 2 LEDs
The following administration uses the services laptop computer connected to media server 2
and the media server Web interface.