AvL Proprietary and Confidential
Content is Subject to Change without Notice Page 102 of 195
Fine Peak Signal Source 3 – 6.4.2
Reference Profile 1 – 6.4.1
Reference Profile 2 – 6.4.1
Reference Satellite Mode – 6.4.1
Run Repeak on Startup – 6.4.1
Run Track After Acquire - 6.4.1
Run Track After Peak - 6.4.1
Run Track on Startup – 6.4.1
RSL 1 Attenuation – 6.4.2
Satellite Polarization Offset – 6.4.3
Scan Signal Source 1 – 6.4.2
Scan Signal Source 2 – 6.4.2
Scan Signal Source 3 – 6.4.2
Skip Acquire Sat State – 6.4.4
Tx Enable Before Fine Peak – 6.4.4
Update Heading After Acquisition – 6.4.1
Use SECANT Correction – 6.4.3
6.1.3 Signal Parameters
Signal Parameters generally correlate to the relationship between RF level and movement of the
antenna system.
Coarse Peak Signal Difference Threshold – 6.5.2
Coarse Peaking Cycles – 6.5.2
Coarse Peaking Maximum Cycles – 6.5.2
Coarse Peaking Mode – 6.5.2
Cross Pattern Coarse Azimuth Velocity – 6.5.4
Cross Pattern Coarse Elevation Velocity – 6.5.4
Cross Pattern Coarse Peaking Height – 6.5.4
Cross Pattern Coarse Peaking Width – 6.5.4
Cross Pattern Coarse Signal Tolerance – 6.5.4
Cross Pattern Fine Azimuth Velocity – 6.5.5
Cross Pattern Fine Elevation Velocity – 6.5.5
Cross Pattern Fine Peaking Height – 6.5.5
Cross Pattern Fine Peaking Width – 6.5.5
Cross Pattern Fine Signal Tolerance – 6.5.5
Fine Peak Signal Difference Threshold – 6.5.3
Fine Peaking Cycles – 6.5.3
Fine Peaking Maximum Cycles – 6.5.3
Fine Peaking Mode – 6.5.3
Line Scan Failure Elevation Step Size – 6.5.11
Line Scan Maximum Elevation Steps – 6.5.11
Modem Based Target Allowed – 6.5.11
Modem Maximum Wait Time – 6.5.11
To Next Page
Loading...